View Single Post
Old September 29, 2012, 10:24 PM   #6
Tom Servo
Join Date: September 27, 2008
Location: Foothills of the Appalachians
Posts: 10,327
Trying that with a new S&W will result in a badly bent frame.
Could you elaborate? I was under the impression that crush fitting meant a final "oomph" of torque, and that the older ones were held by torque as well.

I could be wrong; I've heard it both ways.

Dose the pin date the gun?
Not really, but you can get a good estimate from the serial number. There's a thread at the top to inquire.
In the depth of winter I finally learned that there was in me an invincible summer.
--Albert Camus
Tom Servo is offline  
Page generated in 0.04432 seconds with 7 queries