View Single Post
Old September 29, 2012, 09:56 PM   #4
James K
Staff
 
Join Date: March 17, 1999
Posts: 19,852
Well, no. The barrels were not a crush fit and once the pin was driven out, the barrel was put in the barrel vise and a hammer handle or a piece of 2x2 through the cylinder window used to turn the frame off the barrel. Trying that with a new S&W will result in a badly bent frame.

I agree there is no practical difference.

Jim
__________________
Jim K
James K is offline  
 
Page generated in 0.04222 seconds with 7 queries