View Single Post
Old September 29, 2012, 03:25 PM   #10
Mike Irwin
Join Date: April 13, 2000
Location: Northern Virginia
Posts: 37,450
" Very hard to repair, although, one COULD ream out the stripped hole, superglue a machine screw into the enlarged hole and then have a hopper mount very much like the studs/nuts of the Pro's hopper."

Why couldn't one just get or cut a couple of pieces of screw rod in an appropriate diameter and make their own Pro style studs at the onset and skip all the hassle of the stripped screws?
"The gift which I am sending you is called a dog, and is in fact the most precious and valuable possession of mankind" -Theodorus Gaza

Baby Jesus cries when the fat redneck doesn't have military-grade firepower.
Mike Irwin is offline  
Page generated in 0.03623 seconds with 7 queries