Thread: Pietta "Tail"
View Single Post
Old September 28, 2012, 06:46 PM   #3
Fingers McGee
Senior Member
 
Join Date: March 19, 2008
Location: Missouri
Posts: 1,865
Roshi, Piettas have a more trumpet bell shaped bottom on their grips than found on the Colt/Uberti grips. The waist is also thinner on the Pietta. Here are the dimensions and picture from one of the grip makers sites.


Uberti/Colt dimensions:
•Front vertical edge (A) = 1.06 inch
•Overall height (B) = 3.125 inch
•Width of base (C) 2.187 inch
•Midpoint of A to rear edge (D) = 2 inches

Pietta Dimensions:
•Front verticle edge (A) = 0.95 inches
•Overall height (B) = 3.2 inches
•Width of the base (C) = 2.4 inches
•Centerline of front edge to rear edge (D) = 1.7 inches
__________________
Fingers (Show Me MO smoke) McGee - AKA Man of Many Colts - Alter ego of Diabolical Ken; SASS Regulator 28564-L-TG; Rangemaster and stage writer extraordinaire; Frontiersman, Pistoleer, NRA Endowment Life, NMLRA, SAF, CCRKBA, STORM 327, SV115; Charter member, Central Ozarks Western Shooters
Cynic: A blackguard whose faulty vision see things as they are, not as they should be. Ambrose Bierce

Last edited by Fingers McGee; September 29, 2012 at 06:25 PM. Reason: Left out the "Pietta dimensions:" before the second set of measurements
Fingers McGee is offline  
 
Page generated in 0.04299 seconds with 7 queries