View Single Post
Old September 28, 2012, 04:40 PM   #10
sidewindr
Senior Member
 
Join Date: June 4, 2011
Location: somewhere out there
Posts: 101
No problems with the LNL,with proper setup( same with ALL presses) and the right operator it works flawless, Caliber changes are quick, I won't say as quick as a complete toolhead design but each die can be changed out individually if 2 calibers use some of the same dies. For short runs,if I'm doing another caliber in the LNL,I have the adaptor in my Rock Chucker so all the dies can be swapped in and out with the bushings and the sttings are the same, no adjusting.
sidewindr is offline  
 
Page generated in 0.04455 seconds with 7 queries