Thread: Savage 12F
View Single Post
Old September 28, 2012, 11:41 AM   #2
RKG
Senior Member
 
Join Date: June 18, 2009
Location: Boston
Posts: 264
Put a tight fitting patch on a cleaning rod and start it down the bore. Put a piece of tape on the rod (not the handle, but near the handle; you want the tape to rotate as the patch follows the rifling). Mark a line at the top of the patch and then measure how far you have to push the patch down the bore until the mark on the tape makes one full rotation. That is your twist rate.
RKG is offline  
 
Page generated in 0.04744 seconds with 7 queries