View Single Post
Old September 28, 2012, 09:05 AM   #3
BPowderkeg
Junior member
 
Join Date: September 27, 2011
Posts: 382
i too had to pull the bullets from several hundred rounds of 5.56mm the powder charge was too low, thus causing many failures to cycle. if the cases were crimped i recommend the following.., i have a Dillon XL650, i removed the primer advance part and the de-capping pin then proceeded to reload the already primed cases, the cases went thru the sizing die with ease, thus reforming the neck.
BPowderkeg is offline  
 
Page generated in 0.04616 seconds with 7 queries