View Single Post
Old September 27, 2012, 06:08 PM   #20
1911steelplate
Member
 
Join Date: August 7, 2012
Location: colorado
Posts: 30
I found out the hard way that if the bolt doesn't close all the way the hammer still falls and strikes the firing pin. I had this happen and blow the side of the bolt apart. I sent it back and they were good about repairing the problem, said they had updated the recoil spring with a new one that fixes the problem. But the problem wasn't fixed, if it feeds a round and the bolt stays open a little the firing pin still strikes the back of the round. My new Sig 522 doesn't do that, just sayn. I haven't tryed the h&k or colt ar platforms.
1911steelplate is offline  
 
Page generated in 0.05038 seconds with 7 queries