View Single Post
Old September 26, 2012, 11:44 AM   #14
tobnpr
Senior Member
 
Join Date: August 1, 2010
Location: Tampa Bay
Posts: 3,203
Properly bedded, and with action screws torqued to the same values, I would see little reason for a significant shift in poi.

You said "always have"- so you've removed the action from the stock before, replaced it, and have not had this issue?

I said "properly bedded" because a poorly done bedding job can actually introduce-rather than relieve- stress in the receiver and cause poi shifts.
tobnpr is offline  
 
Page generated in 0.05227 seconds with 7 queries