Thread: M1A EBR build
View Single Post
Old September 25, 2012, 10:34 AM   #3
Tucker 1371
Senior Member
 
Join Date: December 29, 2008
Location: East TN
Posts: 2,635
Thanks Jo, the R&D tinkering around idea sounds good, might try it with the springfield synthetic stock it's in right now. I'm not a master tinkerer or gunsmith so how would you go about cutting a hole to install a rail section?

McMillan has a full length rail they market as an accessory to their MFS-14 stock ,http://www.mcmfamily.com/mcmillan-st...ccessories.php I'm guessing it just mounts in where the web sling would go on a normal stock but I don't know if the VLTOR has that since theyre pushing the CASV so hard.
__________________
Sgt. of Marines, 5th Award Expert Rifle, 237/250
Expert Pistol, 382/400. D Co, 4th CEB, Engineers UP!!
If you start a thread, be active in it. Don't leave us hanging.
OEF 2011 Sangin, Afg. Molon Labe

Last edited by Tucker 1371; September 25, 2012 at 10:41 AM.
Tucker 1371 is offline  
 
Page generated in 0.03506 seconds with 7 queries