View Single Post
Old September 24, 2012, 01:47 PM   #3
AZGlock13
Senior Member
 
Join Date: May 10, 2007
Location: AZ
Posts: 252
and if you don't want finger groove ones, try these:

http://www.pearcegrip.com/Products/Colt/PG-OM2

The only problem you will most likely run into going with either one, is that you will most likely need to acquire full length 1911 grip screws. Remember, the RCS model (both the all black one and the two-tone one) comes with thin grips and thin grip bushings inserted into the frame (which means you currently have thin grip length (short) grip screws). You should be alright keeping the thin grip bushings (shouldn't have to change out the bushings), but will most likely have to get some normal full length 1911 black allen head grip screws to accommodate the normal thickness of the rubber grip panels. Hope this helps.

I have the two-tone Sig 1911 RCS model myself. Great pistol. Good luck.

Last edited by AZGlock13; September 24, 2012 at 01:59 PM.
AZGlock13 is offline  
 
Page generated in 0.04066 seconds with 7 queries