View Single Post
Old September 24, 2012, 01:21 PM   #19
BigJimP
Senior Member
 
Join Date: February 23, 2005
Posts: 11,343
If its done right ...probably not ...

If its done by some "Bubba" in his garage....yes, probably ...

If you have a barrel ported ...or any major changes in a gun done ( like going from Inertia triggers to mechanical triggers ) - I'd suggest you keep copies of the work order ( kind of like you would on a car )..especially if its an expensive gun with retail value over $ 4,000 or so .....to prove the work was done by a well known gunsmith or a reputable shop ( like Briley Mfg ) or if the original mfg did the work, etc...
BigJimP is online now  
 
Page generated in 0.04374 seconds with 7 queries