View Single Post
Old September 24, 2012, 10:07 AM   #1
rajbcpa
Senior Member
 
Join Date: August 27, 2012
Posts: 315
Do 9mm cases get bulged from unsupported chambers?

...so this is a well known problem with 40sw brass that get bulged when used in an unsupported chamber.

Does this happen with 9mm too?

If yes, are there any dies to fix this? These cases are tappered and not stright; right?
rajbcpa is offline  
 
Page generated in 0.03975 seconds with 7 queries