View Single Post
Old September 23, 2012, 08:10 PM   #37
Jim March
Senior Member
 
Join Date: February 14, 1999
Location: Pittsburg, CA, USA
Posts: 7,284
Quote:
And Ubertis makes the Colt parts...
You are a liar.

Back in the 1970s Colt did a short run of open-top cap'n'ball reproductions made with Italian (likely Uberti?) parts. And there is some speculation that the Colt Cowboy (a transfer-bar equipped SAA near-clone under the Colt brand at Ruger prices) had Italian bits in it to some degree, esp. given the horrendous quality control problems with the early specimens. But both those product lines are long since dead, by decades.

Colt does not in the current tense ("makes") use any Italian source parts.
__________________
Jim March
Jim March is offline  
 
Page generated in 0.04404 seconds with 7 queries