The Firing Line Forums - View Single Post

Ruger2014 · September 23, 2012, 04:11 PM

Hi all!

I've been having FTE issues with my Ruger P95. cleaned chamber well, cleaned extractor hook with a pick, brush and Hoppes no.9. After one of the failures, I tilted up the pistol and tapped the side. casing wouldn't fall out, I had to pull it out. I'm wondering if the chamber diameter wasn't machined large enough? Any thought? For the record, this was a replacement barrel installed at the factory for a defect.

September 23, 2012, 04:11 PM	#1
Ruger2014 Member Join Date: February 14, 2012 Posts: 17	P95 FTE Hi all! I've been having FTE issues with my Ruger P95. cleaned chamber well, cleaned extractor hook with a pick, brush and Hoppes no.9. After one of the failures, I tilted up the pistol and tapped the side. casing wouldn't fall out, I had to pull it out. I'm wondering if the chamber diameter wasn't machined large enough? Any thought? For the record, this was a replacement barrel installed at the factory for a defect.