View Single Post
Old September 22, 2012, 02:22 PM   #21
MrMitus
Member
 
Join Date: September 21, 2012
Location: Los Angeles, CA
Posts: 21
Quote:
Two more things no one has mentioned:

1. For AR's and similar you should (need to) full-length resize every time. Forget about neck sizing fired cases: that is for bolt guns.
2. If #1 does not work, and you continue to have sizing/feeding issues, you may need a "small base resizing die". These size the brass a little smaller. Typically, only match (tight) chambered guns may need this. My Mini-14 does NOT.
@Marco Califo - The Hornady die set that I have does say "full length" on it.
MrMitus is offline  
 
Page generated in 0.05047 seconds with 7 queries