View Single Post
Old September 22, 2012, 11:43 AM   #14
MrMitus
Member
 
Join Date: September 21, 2012
Location: Los Angeles, CA
Posts: 21
Quote:
Those are exactly the same bullets I use.

I have the Hornady OAL gauge and Hornady comparator and love them.

When I make my dummy rounds, I go through everything I normally would, just not put in a primer and no powder. To make sure your sizing right when you lower you handle, the shell holder should be just kissing the bottom of the decapper/sizing die. This should give you enough neck tension to hold the bullet.

Ps. If you don't have a good manual and the ABCs of reloading, get them, and read them. The ABCs of Reloading helped me quite a bit. Plus if you can find a local mentor, that would be even better.
@jwrowland77 - I did actually buy "The ABCs of Reloading" and "Hornady Handbook of Cartridge Reloading 8th Edition." I'll have to settle down this evening and start reading. I sometimes lack the patience to sit still and read a book haha.
MrMitus is offline  
 
Page generated in 0.04068 seconds with 7 queries