View Single Post
Old September 21, 2012, 11:04 PM   #10
MrMitus
Member
 
Join Date: September 21, 2012
Location: Los Angeles, CA
Posts: 21
I really appreciate everyone's feedback. Thank you so much.

So when trimming for a case length of 1.760 I seem to be over trimming. I'm using a Hornady Camlock Case Trimmer. I've tried to every so slightly make adjustments and I keep over doing it or under doing it... I guess it's gonna take me some time to get this set right.

In regards to the "shoulder setback" I have to be completely honest and tell you that I'm confused now... I'm not sure I even understand which part of the casing is the shoulder.

What adjustment to my sizing die determines the shoulder setback?
(I can either set the screw lower/higher that has the decapping pin on the end of it or I can set the die itself lower/higher into the press.)
Attached Images
File Type: jpg Case Trimmer.JPG (107.5 KB, 35 views)
File Type: jpg RCBS Case Prep.JPG (137.1 KB, 32 views)

Last edited by MrMitus; September 21, 2012 at 11:25 PM.
MrMitus is offline  
 
Page generated in 0.05122 seconds with 8 queries