View Single Post
Old September 21, 2012, 07:18 PM   #4
jepp2
Senior Member
 
Join Date: December 24, 2008
Location: Loveland, CO
Posts: 1,309
Quote:
Right off the bat my first round jammed in the chamber
Do you realize that when you resize your brass, if you don't properly size them (moving the shoulder back the proper amount) the bolt will not close and result in the "round jamming in the chamber"?

If you don't use either a cartridge gage or a device to measure the amount you are setting back the shoulder, you might not be properly sizing your brass. So don't be too quick on jumping on the cases as being too long.
jepp2 is offline  
 
Page generated in 0.04722 seconds with 7 queries