View Single Post
Old September 21, 2012, 02:27 PM   #14
mehavey
Senior Member
 
Join Date: June 17, 2010
Location: Virginia
Posts: 2,881
Quote:
Originally Posted by B_Hunter
if I did too much it was ever so slightly, the flame just started to change color when pulled them off.
So next time I will not allow any flame color change or red color of the brass
Your method (drill with deepwell socket) was fine. Good on`ya.
Suggest next time only two things:

Just set the propane torch on the bench and hold the drill in your hand.
You can operate in the kitchen that way w/ good light.

Get some 500° TEMPILAQ and paint a small patch ¼" below the shoulder.
When it goes transparent upon heating the neck/shoulder well above, dump the case.
You're precisely/repeatably done.
No guesswork

Last edited by mehavey; September 21, 2012 at 05:20 PM.
mehavey is offline  
 
Page generated in 0.04093 seconds with 7 queries