View Single Post
Old September 20, 2012, 09:08 PM   #1
browninghunter86
Senior Member
 
Join Date: November 14, 2011
Posts: 524
First attempt to anneal brass

So my WW 308 win brass has been fired 3 times and decided to try and anneal without the expensive machines costing a small fortune. I think they turned out pretty good for first attempt.

Clamped drill in vise and had torch set just on the case neck/shoulder junction and ziptied the drill on very low speed(no case wobble). Dropped case into a 12mm deepwell socket and with the lights off as soon as it started to change to a semi reddish color I took it out with a pair of pliers and set in a metal bucket.
Brass was not spot clean like when using stainless media but had tumbled for 3 hours. So I think this may have to do with why the case necks appear "darker". But how far the heat traveled down case appears very consistant


browninghunter86 is offline  
 
Page generated in 0.04261 seconds with 7 queries