View Single Post
Old September 19, 2012, 08:35 PM   #1
Mauser8mm
Senior Member
 
Join Date: September 19, 2012
Location: Near Gainesville Fl.
Posts: 224
Help with VZ-24 Mauser 8mm Scope Mount!

Hi, I have a Mauser VZ-24 I picked up at the local gun shop. It has been sporterized to a good point, but not enough! It is drilled and tapped for scope mounts but I have one problem. The back of the receiver is lower than front and I have been having trouble finding mounts that are high in the back and low in the front. I am going hunting this october, so could somebody help me soon please! Thanks in advance, any info will help! (By the way, it does have a bent bolt)
Mauser8mm is offline  
 
Page generated in 0.04914 seconds with 7 queries