Thread: 8mm mauser vz24
View Single Post
Old September 19, 2012, 07:05 PM   #8
arcticap
Senior Member
 
Join Date: March 15, 2005
Location: Central Connecticut
Posts: 2,973
I know someone who had the barrel replaced on a K98 Mauser. He said that the gunsmith told him that it took 2-3 hours to machine the receiver to fit the barrel because the steel was so hard. And this was done by a Mauser rebarreling expert who advertises on Gunbroker. He provides a lot of info. in his ad and did a nice job. I realize that it's a VZ24 being discussed but the process and effort required may be similar:

http://www.gunbroker.com/Auction/Vie...Item=306766589
arcticap is offline  
 
Page generated in 0.04654 seconds with 7 queries