View Single Post
Old September 19, 2012, 03:15 PM   #6
LivewireBlanco
Member
 
Join Date: September 19, 2012
Location: West Texas
Posts: 51
When inserting a full clip the Op Rod doesn't release until the clip "clicks" into place. While I'm sitting here typing this out this makes my mind think that it could be the Clip Latch itself is worn but then again the Op Rod is held open like it should when it ejects a clip except that it will still have 2-5 rounds left in it.
LivewireBlanco is offline  
 
Page generated in 0.05080 seconds with 7 queries