View Single Post
Old September 18, 2012, 05:31 PM   #26
slugoo
Member
 
Join Date: May 3, 2011
Location: Littleton Colorado
Posts: 77
plastic cover lee

The simple fix for the plastic cover on the lee primers is to take a file on its edge and file a small notch in the bottom center of the plastic cover. Than you take a longish rubber band, loop it into itself so you have 2 rubber bands to work with. Now take the two rubber bands over the whole assembly to the notch you've put in the plastic on the botom, than take the two rubber bands and put them to each corner on the top making a V with the rubber bands. That lid will not come off unless the rubber band breaks. I'm still on the same original plastic covers, have gone thru a dozen rubber bands and 50,000 primers. Charlie
slugoo is offline  
 
Page generated in 0.04180 seconds with 7 queries