Thread: gp100 grips
View Single Post
Old September 15, 2012, 04:35 PM   #2
RsqVet
Senior Member
 
Join Date: February 20, 2005
Posts: 2,349
That should be all that is needed, if you are buying the grips used most folks throw in the locator pin as most are going the other way -- from factory / OEM grips to the Monogrip hence no need for the locator pin.

Also the locator pin is only a big round dowel of alunimum. Anyone, I mean anyone could make one if you have a basic metal shop. Heck it might even be a stock size of round, I just had a GP apart, will have to measure next time. If you wanted to go really fancy you could make it out of stainless to even out the way the gun balances.
RsqVet is offline  
 
Page generated in 0.04660 seconds with 7 queries