View Single Post
Old September 15, 2012, 12:14 PM   #3
brokenanew
Member
 
Join Date: September 14, 2012
Posts: 83
I would but its for an AR15 and for some reason I will have a bullet get pushed back and spill some powder in the chamber(not fun to clean) if I dont crimp on the cannelure. and thats nearly max crimp not on the cannelure and its still pushes a bullet back. everynow and then. not all the time

but if I am using SMKS or VMaxs or any good bullet. no problems. just on the bulk hornady plinking stuff does the prob occur and only when firing. I can handle cycle them fine.

Now that I think about it I think it does it in one particular magazine. I might have to test that.... will let you know. thanks!!
brokenanew is offline  
 
Page generated in 0.04970 seconds with 7 queries