View Single Post
Old September 14, 2012, 04:51 PM   #14
Gerry
Senior Member
 
Join Date: December 24, 2010
Location: Canada
Posts: 382
Quote:
and one of those long handled flexible magnets...for when you drop the detent ball....down the center shaft hole of the loader - when you take the shellplate off to clean under it ...is a good investment too ...
I'm glad I'm not the only one. I think it was about the second time I took the shellplate off when I didn't see the ball and figured it must have dropped and rolled off somewhere in my carelessness. So I looked around the floor, thinking it may have rolled some distance. I spent hours looking for the darn thing. I was ready to call Dillon to order another darn ball, when I couldn't fit the bolt in the middle when trying to assemble the shellplate back on so that parts wouldn't get lost. It took me awhile, but I finally figured out the ball had rolled in there! I also took me awhile to figure out how to get it out (with magnet of course).
Gerry is offline  
 
Page generated in 0.05013 seconds with 7 queries