View Single Post
Old September 14, 2012, 09:50 AM   #11
rajbcpa
Senior Member
 
Join Date: August 27, 2012
Posts: 306
Sizing die alignment issue SOLVED!


I sized a case and unscrewred the die from the press and them tighted the die down. Apparently, this aligned the die with the press.. I then tightened the die down against the lock-n-load bushing and tried a few cases through the resizing die....

Now, there is no issue getting cases into the sizing die....


THANKS EVERYONE FOR ALL THE HELP!


I THINK I WILL APPLY THIS TECHNICH FOR EACH CALIPER..... IT IS A GREAT IDEA!
rajbcpa is offline  
 
Page generated in 0.04042 seconds with 7 queries