View Single Post
Old September 14, 2012, 07:48 AM   #51
Don P
Senior Member
 
Join Date: December 17, 2005
Location: Florida
Posts: 5,338
Quote:
Nicely done, but how? Assume I do not have a machine shop in my garage, which I do not. I do have the SS version though, so no bluing to worry about
Guess I'm fortunate with what I have in my garage. Gun disassembled. I used a file to remove the warning from the barrel and sand paper. I then bead blasted the frame. I then put my buffing wheels in my drill press and polished the cylinder so it shined. I like the look and the contrast of the bead blast and polished cylinder. By no means is my garage a machine shop. Air compressor, bead blast cabinet, grinder, drill press, work bench, vise and a 6' ft. tall tool box. I am a former auto mechanic.
__________________
NRA Life Member, NRA Range Safety Officer, NRA Certified Pistol Instructor, IDPA Safety Officer, USPSA NROI Range Officer,
ICORE Range Officer, ICORE Match Director
,MAG 40 Graduate
As you are, I once was, As I am, You will be.
Don P is offline  
 
Page generated in 0.07698 seconds with 7 queries