View Single Post
Old September 13, 2012, 03:35 PM   #2
HiBC
Senior Member
 
Join Date: November 13, 2006
Posts: 3,815
One way,if you have access to a lathe or a mill or an accurate drill press,would be to drill /ream a hole of the pin size in a piece of flat stock,or if in the lathe,just face the round stock and put in the hole

This is the basic idea of a functional gage.

A vee block may also tell you what you need to know.
HiBC is offline  
 
Page generated in 0.04576 seconds with 7 queries