View Single Post
Old September 12, 2012, 08:17 PM   #9
wncchester
Senior Member
 
Join Date: December 1, 2002
Posts: 2,832
"Does anyone have any ideas on this fun situation..."

Yeah, if you just tweaked the screws and hoped that would fix it.

Dump all powder, remove and clean the contact surfaces of both the body and drum of all impacted powder. Reassemble and tighten the drum screws as directed but on the clean surfaces and try again; the leaks should be gone.
wncchester is offline  
 
Page generated in 0.04247 seconds with 7 queries