View Single Post
Old September 12, 2012, 07:43 PM   #15
Nathan
Senior Member
 
Join Date: July 1, 2001
Posts: 1,985
Let me know what they do for you. WE ALL HAVE this issue! The 40 shell plate and the brass thickness I have seem to encourage this tilting condition. I think the cause is that the shellplates are too high. I thinking machining something off the bottom is the solution, but how to get that done for free. For now, I flick. I have read posts written by other flickers. I'm so good at flicking that really it is all in how I operate the press handle and I only have to flick like 1 in 10!
Nathan is offline  
 
Page generated in 0.04587 seconds with 7 queries