View Single Post
Old September 11, 2012, 07:45 PM   #7
dunerjeff
Senior Member
 
Join Date: March 31, 2011
Location: central Wisconsin
Posts: 440
Just for S&Giggles, take all your dies out and put your sizer in any of the other stations.Run some brass through with only the sizer in the press, and fill the whole shellplate with cases. You will then know if it is station 1 or the die that seems to be causing all of your alignment issues.

PS: take out your depriming stem so it isn't trying to deprime without a place for the old one to go.
__________________
sent via telegram
dunerjeff is offline  
 
Page generated in 0.04510 seconds with 7 queries