View Single Post
Old September 11, 2012, 11:33 AM   #10
COSteve
Senior Member
 
Join Date: September 6, 2009
Posts: 473
I have a Dillon trimmer set up on my 650 with casefeeder and case prep toolheads with trim dies for 30-06, .308, .223/5.56, and even 30 Carbine (special thin toolhead and CH4 trim die). That was I set the trim length at near the maximum case length. Because my cases are trimmed every time I resize and deprime them (if needed) I ensure that the cases are both all the same length as well as having the best neck grip on the bullet. In addition, longer necks help to slow throat erosion.
__________________
Steve

“Remember, no matter where you go, there you are.” - Buckaroo Banzai 1984
"When you find a find a big kettle of crazy, it's best not to stir it." - Dilbert 2009
COSteve is offline  
 
Page generated in 0.04425 seconds with 7 queries