View Single Post
Old September 10, 2012, 04:27 PM   #1
glitch1187
Junior Member
 
Join Date: March 24, 2011
Location: Florida Panhandle
Posts: 2
Marlin model 81 questions

I recently acquired a pretty nice Marlin model 81 tube fed .22. I'm curious, though. When the take-down screw is tightened, the feed tube seems to tighten up against the underside of the barrel. Isn't there suppose to be a consistent gap the entire distance of the two? I wonder if I should sand out the bottom of the stock groove or cork the sides of the stock to relieve the feed tube. Any suggestions?
Also, anyone have a good line on a Marlin aperture peep sight for the model 81?
Thanks in advance.
glitch
glitch1187 is offline  
 
Page generated in 0.04468 seconds with 7 queries