The Firing Line Forums - View Single Post

reloader28 · September 10, 2012, 02:04 PM

The Dremel usually works fine.
You can also put a dab of epoxy or jb weld in the top punch, lower it on the oiled bullet, and let it harden.
Then you have a custom fit.

September 10, 2012, 02:04 PM	#2
reloader28 Senior Member Join Date: October 14, 2009 Location: nw wyoming Posts: 840	The Dremel usually works fine. You can also put a dab of epoxy or jb weld in the top punch, lower it on the oiled bullet, and let it harden. Then you have a custom fit.