View Single Post
Old September 10, 2012, 12:26 PM   #11
BigJimP
Senior Member
 
Join Date: February 23, 2005
Posts: 11,048
I use the Dillon spray lube...( and I use it on all cases ...even with carbide dies because it makes the press run a lot smoother ).

I use a "box top" ... that is about 3" deep ....and 11" X 17" ( like the top of the box that comes off a case of office copy paper )....and I dump 5 or 6 handfulls of cleaned cases into the box lid...make sure they are all flat. Then I "spritz" them with the lube....roll them around ...and spritz them a 2nd time ...( not too heavy ) ....

and let them dry for about 20 min ....and then just run them thru the press.
BigJimP is offline  
 
Page generated in 0.03949 seconds with 7 queries