View Single Post
Old September 10, 2012, 09:55 AM   #1
okiefarmer
Senior Member
 
Join Date: February 20, 2006
Location: Oklahoma
Posts: 381
Issues with a top punch

According to the 'structions, the 311 top punch is called for if sizing/lubing the 358212 pill. This is th 145/147 gr for the 9mm. The ogive is a bit different than the other RN molds like the xxx242 or the xxx311, et al. I am getting a ring impressed into the side of the bullet about halfway down the ogive of the thing. Anyone else have this issue? I thought about taking the dremel and taking the edge off the 311 punch. Any other ideas, like a punch that fit it better.
okiefarmer is offline  
 
Page generated in 0.03982 seconds with 7 queries