View Single Post
Old September 10, 2012, 07:17 AM   #7
derrabe
Junior Member
 
Join Date: September 5, 2012
Posts: 6
Thanks for the advise on the 1/8 in crimp that worked for some of the rounds about 10 of the 25 I loaded up it worked great. About 5 it worked but it seated the bullet farther down in the brass about an .1 or .2 inches.

So can someone tell me what the Min OAL on a 500 round is to see if I need to pull the bullet or if they are still fireable just gonna have more kick?

About 10 rounds still would not fit in the wheel chambers even after that so I think for those I am gonna just pull the bullet and start over. Is there a way to safely remove and unfired primer from a brass?
derrabe is offline  
 
Page generated in 0.04250 seconds with 7 queries