View Single Post
Old September 9, 2012, 10:45 PM   #79
Senior Member
Join Date: October 28, 2006
Location: South Central Michigan...near Ohio, Indiana.
Posts: 3,950
Question: After you load the chambers and close the cylinder, how do you know the cylinder is properly locked into position?
It goes, "Click", when you close the cylinder.

i.e. how do you know the cylinder will spin properly?
Test it for function by dry firing before loading.

How can you tell that all cartridges are seated properly and you have no high primers?
Put your cartridges on a flat surface and try to rock them back and can feel if they have a high primer.

I am assuming that you meant those questions in reference to a revolver without a hammer spur.
Sometimes you get what you pay for, sometimes you only pay more for what you get.
Three shots are not a "group"...they are a "few".

If the Bible is the literal, infallible, unerring word of God...where are all those witches I am supposed to kill? (Exodus 22:18)
dahermit is offline  
Page generated in 0.04272 seconds with 7 queries