View Single Post
Old September 9, 2012, 07:46 PM   #10
impalacustom
Senior Member
 
Join Date: January 26, 2009
Posts: 469
Take the steel ring and put it below the spring (base of the receiver). This isn't chambered for the 2 9/16 is it?
I would say that it is almost impossible to get an A5 to double feed unless parts are broken, even then the carrier will be up and the shells will come out of the loading port.

The part that unlocks the bolt from the barrel is unlocked by the link on the cam , when it moves back it the link changes angle and moves the cam and unlocks the barrel.

I am mobile here but when I get home I can give you instructions on how to remove the bolt if you want. I have pictures of the parts too.

Last edited by impalacustom; September 9, 2012 at 10:00 PM. Reason: spelling
impalacustom is offline  
 
Page generated in 0.04467 seconds with 7 queries