View Single Post
Old September 8, 2012, 06:01 PM   #2
Axelwik
Senior Member
 
Join Date: March 12, 2012
Location: Land of Enchantment
Posts: 371
It's not very hard to cast your own bullets, and a lot less expensive once you get started. If you pan or tumble lube the most expensive piece of equipment would be the mold (they could be sized using a Lee push-through die). A gas check design such as the Lyman 429244 can be used with or without a gas check; with for high velocities and without for low, powder-puff velocities.
Axelwik is offline  
 
Page generated in 0.05541 seconds with 7 queries