Thread: Lake City Brass
View Single Post
Old September 3, 2012, 11:08 PM   #2
Bart B.
Senior Member
 
Join Date: February 15, 2009
Posts: 3,828
I doubt you'll get accuracy with the LC brass as good you do with the Winchester stuff. That brass was probably fired from a machine gun and its case heads are no doubt quite a bit out of square as the bolts in those full auto rifles are not even close to match quality and typically more out of square than commercial rifles have. Resizing those fired cases will not square up the case heads. And unsquare case heads is a well known cause of accuracy problems.
Bart B. is offline  
 
Page generated in 0.04722 seconds with 7 queries