Thread: Figure it out?
View Single Post
Old September 2, 2012, 12:23 AM   #6
Lost Sheep
Senior Member
 
Join Date: January 24, 2009
Location: Anchorage Alaska
Posts: 2,996
Quote:
Originally Posted by poline
I have a lee press, I would need the full lenght sizing die, for that calilber. My rifle is a bolt action.
Then my post #3 was based on incorrect assumptions.

Everything longspurr said is what I was going to say except for the "cheap" Lee press. I would suggest one of the better Lee presses. Classic Cast or Classic Turret if you want to do 300 cases at a time.

But since you already have a press, the full-length sizing die for when neck-sizing only eventually does not do and you have to bump the shoulder back.

When you said you bought a Lee Handloader for $20 I assumed it had to be the mallet-driven kit and that you did not have a press at all.

Lost Sheep
Lost Sheep is offline  
 
Page generated in 0.04440 seconds with 7 queries