View Single Post
Old August 31, 2012, 07:03 PM   #19
wolfgang78
Junior Member
 
Join Date: August 25, 2012
Location: North carolina
Posts: 10
i had the same problem with my LNL press (primer slide locking up). look to see if a little bit of powder is getting down there where the little plunger is....sometimes depending on the type of powder and size, the grains jam up the primer plunger. I took mine apart and used a small file to smooth out the edges and always have a can of computer duster on hand when loading. i have been using this press for about 2 yrs now and havent had any other problems. Just keep it clean and lube up all grease fittings. hope this helps
wolfgang78 is offline  
 
Page generated in 0.04220 seconds with 7 queries