View Single Post
Old August 31, 2012, 03:09 PM   #17
rajbcpa
Senior Member
 
Join Date: August 27, 2012
Posts: 306
Where do you buy parts for the press? I don't see any being sold on the Hornady web cite.

My bent shuttle rod guide is NOT threaded where it goes into the brass cup on the bottom of the press. On occassion, after about 10 cycles, the shuttle rod does come out of the brass cup at the bottom of the press but I cannot tell why this is ocurring.

thx..
rajbcpa is offline  
 
Page generated in 0.04441 seconds with 7 queries