View Single Post
Old August 30, 2012, 01:54 PM   #1
rajbcpa
Senior Member
 
Join Date: August 27, 2012
Posts: 306
What is the extra "gizmo" in the Hornady die set?

Dies are Hornady 40S&W/10MM nitride 3-set dies. The three dies cam fully assembled.

However, there is a single stainless piece (1 3/8 tall) included in the plastic box that has a flat bottom and a lip at the top. It looks like a seating stem without a hollow area for the bullet nose.

This is my first set of Hornady dies. Is this a seating stem for a wad cutter (flat nose) bullet?

I don't see anything on point in the instruction booklet that came with the die set. The instructions seem to be generic for all pistol/rifle die sets.

thx...
rajbcpa is offline  
 
Page generated in 0.04117 seconds with 7 queries