View Single Post
Old August 27, 2012, 05:58 PM   #4
PA-Joe
Senior Member
 
Join Date: June 9, 2010
Location: NEPA
Posts: 732
You did not say what type of ammo you were reloading. If bottle neck/rifle you have to lube the cases before sizing. If pistol check the carbide ring to make certain it does not have a sharp edge. You may alos have to give it a tap to go straight into the die. Are you double tapping to fill the powder measure and to get it all to drop out?
PA-Joe is offline  
 
Page generated in 0.03771 seconds with 7 queries