View Single Post
Old August 25, 2012, 05:28 PM   #5
William T. Watts
Senior Member
 
Join Date: January 20, 2010
Location: Central Arkansas
Posts: 755
Exception to the rule (who's rule?)

Shell holders aren't always interchangeable, I needed a RCBS #14 shell holder for a 45/70, I was sent a lyman replacement after Midsouth assured me the lyman shell holder was a direct replacement/substitute for my RCBS press and hand priming tool. Tain't so, the shell holder would not mount/fit in my RCBS 90200 hand priming tool. This is why I usually insists on Genuine RCBS tools. William

Last edited by William T. Watts; August 26, 2012 at 05:18 PM.
William T. Watts is offline  
 
Page generated in 0.04283 seconds with 7 queries